Open your network preferences and add in a new connection > Interface = VPN > VPN Type = Cisco IPSec > Service Name = A sensible name you will recognise, (like connection to work, or home etc.) I’m assuming you have already configured the firewall, if not see the article below Ĭisco ASA5500 Client IPSEC VPN Access Solution But modern versions of OSX have the Cisco IPSec VPN client built into them. There is/was a VPN client for Mac OSX which you can still download. If you use the recommended address mask, some routes assumed by the VPN configuration might be ignored.Here we are dealing with the older IPSEC VPN method of remote VPNs, NOT An圜onnect. It’s recommend that re-keying times on the server be set to one hour.ĪSA address mask: Make sure all device address pool masks are either not set, or set to 255.255.255.255. Rekeying of phase 1: Not currently supported. Load balancing: Supported and can be enabled. Standard NAT traversal: Supported and can be enabled (IPsec over TCP isn’t supported). Perfect Forward Secrecy (PFS): For IKE phase 2, if PFS is used, the Diffie-Hellman Group must be the same as was used for IKE phase 1. IKE exchange modes: Aggressive mode for preshared key and hybrid authentication, or Main mode for certificate authentication.Įncryption algorithms: 3DES, AES-128 or AES256.Īuthentication algorithms: HMAC-MD5 or HMAC-SHA1.ĭiffie-Hellman Groups: Group 2 is required for pre-shared key and hybrid authentication, group 2 with 3DES and AES-128 for certificate authentication, and group 2 or 5 with AES-256. You can specify these settings to define how IPsec is implemented:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |